Page 59 - Load Bank Rentals

LOAD CUBE R

2500KW Load Bank System

The Load Bank is a completely self-
contained, freestanding unit which
includes all resistive load elements,
load control devices, load element
branch circuit fuse protection, main
load bus and terminals, cooling system,
control power supply, unit controller and
malfunction detection system and type
enclosure.
System Protection

Sensors, alarms (alarm message on
remote operator interface terminal),
lock-outs as appropriate, for the
following:
• Fan failure, each of two fans
• High exhaust temperature, each of
two fans
• High intake temperature
• High interior temperature, sensed at
three points
• Louver open/closed, each of eight
louvers
Load Elements
Simplex Powr-Web: Open wire,
helically wound, chromium alloy, load Inductive elements: Non-saturable, Control Wiring
element thermally derated to 60%. 5% air-gap type, iron-core power inductors.
tolerance, 2% balance. .995 p.f. Element 5% tolerance, 1% waveform distortion, 105°C
wire mechanically supported over 0.05 power factor, 150°C rise, 220°C
entire length such that if a wire should insulation. Power Connection
break, the broken wire segments will
not short to adjacent conductors or to Basic Dimensions Plated bus bar behind hinge-up access
ground. Load elements are individually door.
serviceable and replaceable in the field 96.5”W x 110.25”H x 130”D.
without major disassembly of the load Control Connection
bank. The load elements are installed Load Control
in slide-out, removable trays such that
any element is easily accessed without Branch circuit contactors, each 50 KW Connector plugs with recessed
disturbing any other elements. resistive circuit max or each 75kvar protective well.
All materials used in the mounting inductive circuit max. Inductive circuits Cooling
are double-break. Contactors have
and installation of the load elements enclosed silver surfaced contacts,
are suitable for the temperatures 120V coils; electrically operated and Forced air, horizontal airflow. 2 x 10HP,
encountered, in both normal operation electrically held. 3-phase, TEFC motor direct driving cast
and under fault conditions. Materials aluminum fan blades. Circuit breaker
in direct contact with the element wire combination motor starter.
are ceramic. Other materials which Element Circuit Protection
structurally support the load elements Enclosure
and/or which form the hot air duct Branch circuit fuses, each 50KW
within which the elements are mounted resistive branch circuit max , each Type 3R control section; Type 3R power
are steel, stainless steel or aluminum. 75kvar inductive branch circuit max. section. Epoxy primed, polyurethane
Plastics and glass reinforced plastic 600v, 200kAIC, current limiting type. finish coating, dark gray. Power
materials and flammable materials are operated ventilation louvers. Lifting
not used for installation, support and Power Wiring eyes, forklift channels, hinged, lockable,
mounting of load elements or in the access doors with flush latches.
construction of the load bank hot air 150°C insulated; color-coded and
duct. numbered.

© 2021 Simplex, Inc. All Rights Reserved. SIMPLEX INC.
Printed in the USA • 2103-02.00 • Page 59 5300 Rising Moon Road, Springfield, IL 62711 • simplexdirect.com • 800-637-8603
Design subject to change without notice. Nationwide Manufacturing (ISO9001: 2015 certified)